| Tool and Equipment |
Click on pic |
Cost |
Enter
Qty |
2-Stroke
leak down tester
Use this tool to check for air leaks in two-stroke engines. It includes air pressure gauge, pump-up bulb and most fittings and adapters for single and twin-cylinder two-stroke motorcycle engines. Packed in a convenient carrying case with instructions.
Motion Pro |
 |
$229.95 |
|
4-Stroke
leak down tester
Designed to check the amount of cylinder leakage in a 4-stroke engines. With an air source of 70 to 160 PSI, this system will pressurize the cylinder with 60 PSI of air. Gauge registers the total percentage of leakage past the rings, head gasket, intake and exhaust valves. System includes 10, 12 & 14mm spark plug adapters, regulator & gauge. This tester will speed up troubleshooting and will help to isolate bad components.
Motion Pro |
 |
$169.95 |
|
Nitrogen
shock gauge and filler
The features of this tool include 300 psi capacity, bleeder valve and T-handle plunger pin chuck. Swivel chuck has a 12" flexible hose. Comes complete with instructions, carrying box and schrader valve extension (required on some Showa shocks).
Nitrogen bottles available at any welding supply house. Motion Pro |
 |
$189.95 |
|
Clutch
holding tool
Made from medium carbon steel with hardened jaws. It feature spanner pins and the jaws open up to 5" wide.
It's ideal for holding clutch hubs, flywheels, gears, sprockets, etc.
Motion Pro |
 |
$29.95 |
|
Safety
wire kit
Safety wire pliers and a 25' roll of .032" stainless steel
safety wire. Helix |
 |
$26.95 |
|
Chain
alignment tool
Designed for quick and accurate alignment, this tool clamps squarely to the rear sprocket so the alignment rod can indicate sprocket alignment.
Motion Pro |
 |
$25.95 |
|
Crankcase
separator
The Motion Pro crankcase separator features an innovative design putting it above anything else you have ever seen. Featuring an inner sleeve, the
Motion Pro case separator does not suffer from the binding and breakage affecting similar tools on the market. |
 |
$139.95 |
|
Fork
oil level tool
Thanks to Race Tech, you can have the ultimate tool for maintaining your fork oil level. This Fork Oil Level Tool will enable more efficient and accurate fork oil adjustments for pit or shop use. It just can't get any easier than this.
TFOL02 |
 |
$89.95 |
|
Blind
bearing remover set - from Motion Pro
Pulls bearing out of those blind holes in engine cases etc. Set includes 30, 25, 20, 17, 15, 12, 10 and 8mm collets.
2 pound slide hammer. Crossbar type shaft allows easy collet removal. Necessary tool for most transmission rebuilds.
Can be used for wheel bearing removal |
 |
$179.95 |
|
